it runs! but...

speedyrb29 · Post by **speedyrb29** » Thu Sep 13, 2007 10:36 am

ok my srt engine runs good just my belts are making some funky noise. im not worried about. but i got 5 codes only worried about 3 since the other 2 are about the nvld and the battery temp thing.

0688 asd relay sense circuit low?????

0508 idle air control low or somthing like that???

*0513 invalid skim?!?!? im getting this code yet it will still start and run? but if i dont put a jey threw the skim mod it will start and die right away so idk how my key could not match the skim unless it would have to do with the gauge cluster but i doubt it.

its a stage 1 ecu with the skim and key all sapposely from the same car and i can turn the car with out it dieing right away like it dose with out a skim so idk y its giving this code any ideas????

Post by **Diablo0** » Thu Sep 13, 2007 10:38 am

I take it you didn't swap out your body harness did you?

speedyrb29 · Post by **speedyrb29** » Thu Sep 13, 2007 6:29 pm

not yet but i do have it. is that y im getting tthat skim code? i know that has to do with the nvld.

Post by **Diablo0** » Fri Sep 14, 2007 9:37 am

It's also why you're getting the 508 and 688, once you swap it over and hook everything up you should get rid of the 508 and 688

The SKIM you shouldn't get unless you didn't swap over the SKIM module on the steering column to match the PCM an also use a key that matches the SKIM. However, some people are getting around it somehow... I think refect has done it but I'm still not completely understanding how they're doing it

speedyrb29 · Post by **speedyrb29** » Fri Sep 14, 2007 10:22 pm

i think the problem with the skim could be if the stage 1 has been reflashed it will throw that code...i read it some where on an old post about the srt swap about the skims and such. hey it works im not to worried about it just need to figure out how to get my clutch to disengauge lol

Post by **Diablo0** » Tue Sep 18, 2007 9:02 am

Did you swap pedal assemblies so you're using the SRT clutch pedal?

refect · Post by **refect** » Tue Sep 18, 2007 12:11 pm

i get 0513 in mine. i am using stage 0 ecu though, but some how mine starts and stays running too without the skism module swapped in. the 513 code is nothing to worry about as long as your car starts and stays running.

speedyrb29 · Post by **speedyrb29** » Tue Sep 18, 2007 1:12 pm

yea i swapped the srt pedals in there.

Post by **Diablo0** » Tue Sep 18, 2007 3:18 pm

Swap over the SRT master and slave as well as the little plastic cap thats on the end of the slave cylinder pushrod? Also have the clutch pedal adjusted to the highest point?