Lowered My Ram

LaidNeon · Post by **LaidNeon** » Mon Sep 24, 2007 12:05 am

I was bored today & i really didn't feel like messing with the neon so i said fuck it, lets lower the Dodge!! I did an axle flip in the the rear & i plan on getting the front lowered later. I just need a ball joint splitter to get the spindles off so the old springs can be removed. I also decided to throw on the OG dodge emblem as well

REAR BEFORE

REAR AFTER

hybrid-Srt2001 · Post by **hybrid-Srt2001** » Mon Sep 24, 2007 1:38 am

are you putting on a roll pan, cause that bumper looks bad with all the other shaved stuff.

LaidNeon · Post by **LaidNeon** » Mon Sep 24, 2007 2:21 am

dunno yet, i want to but i don't want to. I have a Hitch Receiver that isn't mounted back in place that sticks out even with the bumper. I want to keep the receiver, but it will stick too far out from the rollpan. I'm also considering molding the bumper in instead of a roll pan

KrackstaR · Post by **KrackstaR** » Mon Sep 24, 2007 12:36 pm

yeah dude dont forget that this sucka is for towing..lol

Looks good lowared i thought it was going to be slammed...

Panhead · Post by **Panhead** » Mon Sep 24, 2007 2:16 pm

truck looks great man. love the old skool dodge badge.

LaidNeon · Post by **LaidNeon** » Mon Sep 24, 2007 10:51 pm

KrackstaR wrote:yeah dude dont forget that this sucka is for towing..lol

Looks good lowared i thought it was going to be slammed...

well since the trailer i use to barrow from work got jacked, i will not be towing my neon again till i buy my own trailer. But i plan on bagging the truck right after the neon is done. This is just what happens when i get bored & start cutting Sh!t up

Well I Finished up the front end today. Turns out my upper ball joint on the passenger side is toast, so i get the lovely task of replacing it. I have a little bit of camber issue in the front, but it was expected. Might modify the LCA or just buy some tubular ones to fix the problem. Anyways, here's the pics

BEFORE

AFTER