2.0 H.O

Have a question that your not sure what category it fits into or isn't really a specific question about a specific part? Ask it here...
Post Reply
lowone01
2GN Member
Posts: 25
Joined: Mon Nov 19, 2007 7:59 pm

2.0 H.O

Post by lowone01 » Mon Nov 19, 2007 8:07 pm

Hi guys. I am new here and i just bought a new but used 02 neon and i was wondering is there a way to tell if the motor is a plain 2.0 or a 2.0 H.O

NeonOn19s
2GN Member
Posts: 2074
Joined: Mon Nov 07, 2005 11:44 am
Location: Spring,TX

Post by NeonOn19s » Mon Nov 19, 2007 8:14 pm

The 2.o H.O is the R/T or ACR models. The Intake Manifold should be a Cast Aluminum Intake. Not the Plastic. My car is a R/T w/ 2.0 H.O I hope that this helps...
| Nathan |
Image


Official "I'm Going to Drive My Neon til it Dies" Club Member # 72
Semper Fi!!! USMC

Hudson_Neon
2GN Member
Posts: 3371
Joined: Wed Mar 14, 2007 4:50 pm

Post by Hudson_Neon » Mon Nov 19, 2007 8:15 pm

is it an R/T or is it some other sub-model?

User avatar
half_twisted
2GN Member
Posts: 729
Joined: Thu Jul 21, 2005 11:31 pm
Location: Anaheim Ca.
Contact:

Post by half_twisted » Mon Nov 19, 2007 8:16 pm

well the the h/o model has the magnum cast iron intake manifold while the base model has a simple black carbone graphite intake.
Image

occasional demons
Junior Admin
Posts: 20064
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Mon Nov 19, 2007 8:17 pm

http://www.neons.org/vin/

The other .org does have some usefulness....
Bill
Probably shouldn't listen to anything your penis says, that guy's a dick.
Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
Too much time spent here is a sign of a bad case of Ownaneonvirus.

2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap

lowone01
2GN Member
Posts: 25
Joined: Mon Nov 19, 2007 7:59 pm

Post by lowone01 » Mon Nov 19, 2007 8:20 pm

thank you all very much for the info it will help

Post Reply

Return to “General 2nd Gen Discussion”