YES!!!!! Always fun to get a new part in the mail... YES!!!

Post by **Diablo0** » Thu Sep 21, 2006 9:05 pm

Same height, doesn't hang down any lower than the stocker.

satrnbmb · Post by **satrnbmb** » Sat Sep 23, 2006 10:34 pm

Diablo0 wrote:
satrnbmb wrote:Not to totally bring this back from the dead, but what do you use for a gasket and what's this RTV stuff? I've got a crank scraper I want to install.
Jesus, old thread! lol

You can reuse your stock gasket as it's made with rubber and can be reused as long as you don't damage it in pulling it off. I myself bought another gasket to play safe and the RTV is used to seal where I wanna say the bed plate meets the oil pump assembly. There is a little joint there where oil can seap out if RTV isn't used. It's like a liquid gasket that hardens into a rubber of sorts.

See now that's what I was after. I know it's gasket in a tube, but those locations to pay attention to are very important. Thanks J.

Post by **Diablo0** » Sat Sep 23, 2006 11:12 pm

No prob man