Howdy,
I got an R/T bumper with the stock foglights and i'm trying to put it on a base 2001 Neon. I don't have the harness for the foglights, so i'm wondering how i could hook up the fogs to turn on with my headlights. The bulbs have 2 prongs, i'm assuming 1 pos. and 1 neg., anyone have any ideas on how i could set this up?
It would be GREATLY appreciated!
How to install stock fog lights?
-
LCPLPunk
- 2GN Member
- Posts: 1238
- Joined: Sat May 14, 2005 10:28 pm
- Location: Central Florida
- Contact:
How to install stock fog lights?
2001 Neon R/T
Deyeme Motor Mounts, Booger Bushings, JohnnyMopar Cradle Bushings, SRT Silver shift knob, Maddog STS, SRT Rear Seat, K&N WAI, Magnecore Wires, Mobil 1 Full Synthetic Oil, Coil pack heat shield
""The bitterest tears shed over graves are for words left unsaid and deeds left undone" - Harriet Beecher Stowe"
Deyeme Motor Mounts, Booger Bushings, JohnnyMopar Cradle Bushings, SRT Silver shift knob, Maddog STS, SRT Rear Seat, K&N WAI, Magnecore Wires, Mobil 1 Full Synthetic Oil, Coil pack heat shield
""The bitterest tears shed over graves are for words left unsaid and deeds left undone" - Harriet Beecher Stowe"
-
2k2patriotblueneon
- 2GN Member
- Posts: 923
- Joined: Sun Jul 11, 2004 3:17 pm
- Location: New York State
- Contact:
Well you say its two prongs, find out which is pos and which is neg. Then hook up a toggle of floater switch whatever you prefer. Or if you want the stock look buy a new harness....but thats mucho bux.
2002 Dodge Neon SE
Mopar Stage 3 Coilovers w/Energy Suspension Polyurethane Bushings
SRT Swap in progress
SRT is powered by an AGP 50 trim stage 4 ball bearing turbo kit
When finished will run no less then 400 HP.
Mopar Stage 3 Coilovers w/Energy Suspension Polyurethane Bushings
SRT Swap in progress
SRT is powered by an AGP 50 trim stage 4 ball bearing turbo kit
When finished will run no less then 400 HP.