Aeromotive 1:1 on stock fuel rail

weber · Post by **weber** » Sat Mar 15, 2008 3:26 pm

Its been 3 years since I have been hardcore into this turbo stuff

I'm a little rusty up in the head and can't remember fitting sizes.

I'm running the stock rail, and I can't remember the size off the end of it. Was it -4 an or 1/4 NPT? ...anyway, anybody have an Aeromotive 1:1 regulator hooked directly to the end of the rail? If so...link me up to what fitting I need to do so. Its the -6 AN inlet/outlet model.

Kevin_GP · Post by **Kevin_GP** » Sun Mar 16, 2008 6:38 pm

stock rail is -4, so you will need a -4 female to -6 male fitting for it to bolt to the rail. I didn't bolt mine to the rail though, I have mine bolted near the rad support.