Request from people with 2000 neons

spencersummerfield · Post by **spencersummerfield** » Wed May 28, 2008 10:47 am

Can some one take a good picture of there throttle body.

Specifically the IAC. I want to see which way is the right way up.... I need to see the wire colors on the connector.

thanks!

NeonOn19s · Post by **NeonOn19s** » Wed May 28, 2008 10:49 am

Is this what you wanted????

03blackrt · Post by **03blackrt** » Wed May 28, 2008 10:55 am

NeonOn19s · Post by **NeonOn19s** » Wed May 28, 2008 10:56 am

my bad..... Still not finished with my first coffee....

spencersummerfield · Post by **spencersummerfield** » Wed May 28, 2008 11:20 am

thanks.

lexeon · Post by **lexeon** » Thu May 29, 2008 2:56 pm

what kind of fuel rail cover is that?

01neon01 · Post by **01neon01** » Thu May 29, 2008 5:07 pm

i think its actually a whole new fuel rail made by boomba

2k1MotorSport · Post by **2k1MotorSport** » Thu May 29, 2008 6:18 pm

yeah.. they are nice, but also costly.

NeonOn19s · Post by **NeonOn19s** » Thu May 29, 2008 10:21 pm

lexeon wrote:what kind of fuel rail cover is that?

Its actually the Boomba fuel rail. I love it.. Had to make a few modifications to fit the 2.0 engine.

lexeon · Post by **lexeon** » Fri May 30, 2008 11:06 am

what sort of modifications?

NeonOn19s · Post by **NeonOn19s** » Fri May 30, 2008 11:15 am

because of the R/T Intake manifold curves up higher than the SRT, the cooling fins on the sides I had ot grind down so the injectors will seat right. The mounting bracket to teh manifold I had to drill out a bit to line up correctly. No leaks!!!!!

gilly02le · Post by **gilly02le** » Fri May 30, 2008 12:28 pm

^^^^These fins(circled in red) Need to be ground down to make the Boomba Fuel Rail fit properly.... I Just Wonder how much that weakens the intake manifold, being that those are there for strength.