

Once I had that done, I then put a similar layer on top to hold the box in place. Only 3 sides were required because the box wont slide forward more than 1/4" before hitting the big metal bulge of the rear deck.


Here you can see how the box sits in it. I left space on either side to account for the carpet that will be on the box and on the base.




Next comes the amprack. I decided to mount this on top of the box because of my altered trunk light setup. It creates a nice effect at night.

The amprack wont be a perminant fixture on the box, and will have basically a "false" back to the box, covering up the backside of the box and giving me a place to mount my fuse block, ground distrobution block, and my 3-way crossover(this one is currently on the rear passanger floor). The bar on the bottom of the amprack will provide a "stop" point for when its installed so that it wont slide forward and will always be in the same location.


See?


That's it for now, i have to get ready for work...







































