Pic Request

BigDutch · Post by **BigDutch** » Wed Jul 16, 2008 8:57 am

Hello,

I am hoping someone on here has this...

I would like to know if there is anyone with a 03+ with a rear lip & SRT rear section?

If so, could you post a few pic's?

Thanks
Jordan

juvy · Post by **juvy** » Wed Jul 16, 2008 6:58 pm

Not the SRT rear but close

BigDutch · Post by **BigDutch** » Thu Jul 17, 2008 8:23 am

Thanks,

How much work was it to make it work?

juvy · Post by **juvy** » Thu Jul 17, 2008 6:36 pm

I imagine all you have to do is get someone to cut the bumper to allow the exhaust to come out. Probably cost $25 to get it cut. I bought it with the r/t exhaust and the bumper already cut. Shouldn't be too much work

BigDutch · Post by **BigDutch** » Thu Jul 17, 2008 8:53 pm

Yeah, unfortunatly the SRT exhaust is spaced further than the R/T is. I currently have an R/T and its out about 2" each side.

Does anyone know if they make the lip without the holes cut in them?

bone-yard-racing · Post by **bone-yard-racing** » Thu Jul 17, 2008 9:01 pm

That is how it comes you have to cut the holes yourself. I can post up the instructions where it shows you where to make the cut if you like.

BigDutch · Post by **BigDutch** » Thu Jul 17, 2008 9:05 pm

Thanks I'll keep that in mind.

The plan is to locate a '03 + rear bumper and find a rear lip to give the tail of my R/T a bit more of an aggressive look.

I have found a bumper just need to get a black rear lip...