rear window door questions

[yankeesking]

Last week ago, I broke my rear door window because I left my key inside and no cash or wallet with me. I was in nowhere at farm area. No cell works. I pulled over because I felt tire shakes which I thought it was flat so I got out of car and closed the door by mistake. It locked. Anyway I went to junk yard and got rear window for my 00 neon. I like to know how I can install window in the side door? Its rear side door. I already removed door panel but no idea how to put window there. Thanks for your time.

[Donkeypuncher]

DOOR GLASS
REMOVAL
(1) Remove door trim panel and inner belt weatherstrip.
(2) Lower the window to 50 mm (2 ins.) from bottom
of travel.
(3) Loosen bolts attaching rear lower run channel
to inner door panel (Fig. 4).
(4) Remove rear run channel from door.
(5) Loosen screws attaching window regulator
channel to glass.
(6) Slide channel rearward to allow screw heads to
pass through key hole slots in channel.
(7) Remove glass from roller channel.
(8.) Lift door glass upward out of the opening at
the top of door.


Fig. 4 (Rear Door/Window Diagram)


INSTALLATION
(1) Lower door glass through opening in top of
door and into position in the window regulator.
(2) Position door glass onto roller channel.
(3) Slide roller channel forward to allow screw
heads to engage key hole slots in channel.
(4) Tighten screws attaching window regulator
roller channel to glass.
(5) Install inner door belt door trim panel inner
belt weatherstrip.
(6) Operate window and check for interference.
Adjust glass as necessary.



Seems pretty straight forward. Sometimes it can be a little frustrating lining up the glass and the channel.

[PioneerUrban]

Wow! That's some good info!

Thanks!