WOT and RPM switch

ZeroChad · Post by **ZeroChad** » Tue Sep 02, 2008 1:33 pm

I'm having trouble getting my switches to function properly. They're both being used to control my butterfly actuator on my mag intake.

Has anyone here gotten the Zex WOT TPS switch to work properly? I have it hooked up properly, yet it actuates at around 1/8 throttle. I'm thinking that it could be due to different voltage readings form having the car running or off (during programming).

The Summit racing RPM switch said it shouldn't need a tach adapter. Has anyone used this piece before? No matter what cyl setting I have it on its not functioning properly. I'm considering using the low voltage signal wire, but I'm not sure what the voltage is for the wires leading to the coil pack. My voltmeter isn't working so I can't really check.

I have both switches inside of the cabin and all of the connections seem to be right. I'll post a wiring diagram of my relay logic if I can find it.

ZeroChad · Post by **ZeroChad** » Thu Sep 04, 2008 4:44 pm

Bump for some input

Danteneon · Post by **Danteneon** » Thu Sep 04, 2008 5:54 pm

I can't help you on this one, but I can move you to the right section

*Edit* Errr...maybe not. That was supposed to go to Engine

ZeroChad · Post by **ZeroChad** » Thu Sep 04, 2008 11:29 pm

Epic Fail

60trim · Post by **60trim** » Fri Sep 05, 2008 1:40 am

I think you do need the MSD tach adapter to convert your voltage readings.

Danteneon · Post by **Danteneon** » Fri Sep 05, 2008 12:05 pm

ZeroChad wrote: Epic Fail

Yep, I live up to the

well

quicksilvr · Post by **quicksilvr** » Thu Sep 11, 2008 12:28 am

ZeroChad wrote:I'm having trouble getting my switches to function properly. They're both being used to control my butterfly actuator on my mag intake.

Has anyone here gotten the Zex WOT TPS switch to work properly? I have it hooked up properly, yet it actuates at around 1/8 throttle. I'm thinking that it could be due to different voltage readings form having the car running or off (during programming).

The Summit racing RPM switch said it shouldn't need a tach adapter. Has anyone used this piece before? No matter what cyl setting I have it on its not functioning properly. I'm considering using the low voltage signal wire, but I'm not sure what the voltage is for the wires leading to the coil pack. My voltmeter isn't working so I can't really check.

I have both switches inside of the cabin and all of the connections seem to be right. I'll post a wiring diagram of my relay logic if I can find it.

My ZEX WOT has always worked like it's supposed to. I use the MSD rpm switch (can't remember the model number, check my garage) and it is set to 2Cyl. Is your relay layout setup so the WOT is before the RPM switch? It should be, that's how mine is and it's always worked. The only thing I've noticed is I really have to be full WOT for it to active. Sometimes I think I am, and i don't hear it open....I push just a little harder, and WAAAAAHHHHH!, there is goes.

2GN.ORG

WOT and RPM switch

WOT and RPM switch

Re: WOT and RPM switch