srt-4 starter

Xtian · Post by **Xtian** » Sat Dec 27, 2008 4:22 pm

will it fit my '01 SE? is it going to make it start quieter?
I am trying to make my car as silent as it could be.

NickKo · Post by **NickKo** » Sat Dec 27, 2008 4:26 pm

I don't see why it would make the car start quieter.... or if it would fit....

- Nick

Graphite SRT · Post by **Graphite SRT** » Sat Dec 27, 2008 8:35 pm

i don't think it will make it any quieter but it will fit. I have a 2.0 starter on my SRT-4 engine

They carry different part numbers but i have no idea what or why their is a difference.

excon · Post by **excon** » Sat Dec 27, 2008 11:26 pm

why are you trying to make your car quiet? trying to make it a sleeper, or a luxury car?

Post by **occasional demons** » Sun Dec 28, 2008 12:35 am

So the GF's dad doesn't hear him leave!

Damn teenager's!

The only thing you can try is sound deadening around the starter/bellhousing. But it would need to be the black sticky lead foil backed stuff, other wise you may have an oil soaked mess that could catch fire.

Fuck it, ain't my daughter.

patiofurnituregt · Post by **patiofurnituregt** » Sun Dec 28, 2008 5:51 am

Perhaps the motors themselves are the same dimension but if I recall the teeth ont the SRT flexplate is different than the regular neon...I just remember there was a reason when I did my tranny swap that I had to use the SRT starter.

Graphite SRT · Post by **Graphite SRT** » Sun Dec 28, 2008 9:22 am

it must have to do with the trans bell housing then because i am using the 2.0 starter as i did not swap the trans