SRT6 Swap

v95 · Post by **v95** » Thu Mar 05, 2009 5:32 pm

ok i was thinking of making custom poly mount inserts would i be better buying a block and shapping it or just puying ones from an after market company and cutting out a fill for them. cause if i make my own i think i'm going to try to make a more streghtyer insert but it might take a lot of time to cut and shape.

bone-yard-racing · Post by **bone-yard-racing** » Thu Mar 05, 2009 10:12 pm

Delrin or aluminum

v95 · Post by **v95** » Thu Mar 05, 2009 10:51 pm

bone-yard-racing wrote:Delrin or aluminum

which would be better for a 500+hp engine with 462 torque

Post by **racer12306** » Fri Mar 06, 2009 5:44 am

aluminum

good aluminum

time to start researching the different kinds. you want one that is tough and not brittle.

v95 · Post by **v95** » Fri Mar 06, 2009 11:59 pm

yeah i just got a look at some prices guess per mount and rounded to 245 per if i make them and about 500+ if some machine shop does it

Post by **racer12306** » Sat Mar 07, 2009 12:19 am

sounds about right. but you better be able to provide good drawings to the shop so as not to make them 2 or 6 times.

machine shop rate is probably in the area of $75/hour

v95 · Post by **v95** » Mon Mar 16, 2009 2:01 pm

so i have finally hit a dead end where money is starting to thin out but now i need a new idea for suspension where it will be stiff enough to support the engine and but still provide great handling i was looking into a couple of places any good ideas guys

v95 · Post by **v95** » Mon Mar 23, 2009 1:36 pm

for any who want to try this process i'll make a list. I selling the project off to a mechanic cause I do not have the time nor any more money or any more energy to spend on it. its become a money pit and its only been like a couple weeks.

i'll post a list of everything that you need to get for this kind of a project sometime later this evening for those who want to try it.

For starters form the top of my head

suspension:

bushing recomend custom made by any company that deals with that sort of stuff expect 700 for every suspension bushing from what i understand
26mm or > sawy bars front and 22mm back
stronger strut bars
harder springs in front with lighter in rear
possible air ride is best but not recomended for this cause of cost.
also recomend stronger tie rods
srt 6 axels are fine but would recomend the porsche axels for better strength.

Custom mounts soild alum. is good with custom made bushings around 550 peer mount custom made to fit neon

breaking have still been looking into this but recomend a srt6 performance break system its has i think a 16" rotar and you can fit a 18's on the car.

hybrid-Srt2001 · Post by **hybrid-Srt2001** » Mon Mar 23, 2009 2:15 pm

Didn't we try to tell you this would happen?

v95 · Post by **v95** » Tue Mar 24, 2009 10:36 am

yeah but at least I'm getting my money back and then some. but hey it was a fun idea and want to see it get finished so hopefully the mechanic will.

two more day and she is no longer mine.

2GN.ORG

SRT6 Swap

SRT 6 Swap to which of the cars.