How To: Install SRT-4 Gauge in my 02

2gNeon4life · Post by **2gNeon4life** » Fri Feb 27, 2009 9:35 am

Ok here is what's going on. i have a 2002 non tach dodge neon and i am about to buy a srt-4 gauge cluster and i need to know what i need to make it work properly? What wires, everything i need to know, including what to watch out for etc. If anyone has any idea on what i need to know and what i need to buy to make this successful PLEASE LET ME KNOW. Thank you again for your comments.

GunmetalNeon · Post by **GunmetalNeon** » Fri Feb 27, 2009 10:43 am

Well basically you take out the screws on each side of the dash top. Then the two screws that are in the middle vent on top of the dash. Pull the pillars off each side. Then pull your dash off. Pull off a couple screws under the steering wheel. then carefully pull the little plastic piece right underneath the cluster that somewhat covers it. On the cluster itself there are 4 screws total. Two on top two on bottom. Once you take those out the cluster comes right out. Take the SRT one and slide it right in, because it's a direct fit(no wiring). Put all the screws and plastic pieces back in. Consume beer for job well done. Enjoy your new cluster.

I believe that's it, correct me if I'm wrong I haven't pulled my dash apart in a couple months.

Post by **racer12306** » Fri Feb 27, 2009 10:48 am

whoops,

moving to interior, i missed gauge cluster, rather than gauge pod.

2gNeon4life · Post by **2gNeon4life** » Fri Feb 27, 2009 2:01 pm

Cool thanks a lot. Now i know my car doesn't have a tach should i wire it and have it grounded as well?

GunmetalNeon · Post by **GunmetalNeon** » Fri Feb 27, 2009 3:06 pm

The tach will work automatically. It comes from the computer. You don't need to wire anything.