alignment question

Neon4Life · Post by **Neon4Life** » Wed Mar 11, 2009 4:17 pm

so i needed some camber bolts to adjust my camber on my right rear wheel. ok i got some from the dealership.they game me the smaller bolt kind. so what im asking is what part is actually the one being moved. like is the strut being moved then u tighten the bolt.( with the smaller ones in it) ??

latief · Post by **latief** » Wed Mar 11, 2009 4:41 pm

http://www.spcperformance.com/PROD_DIR/ ... 1250&cmd3=

Neon4Life · Post by **Neon4Life** » Wed Mar 11, 2009 4:43 pm

no but see they didnt give me that kind of bolt. they game me the kind that is just smaller bolt but it doesnt look like that.

Post by **occasional demons** » Wed Mar 11, 2009 5:19 pm

With the smaller diameter bolt it lets the knucle pivot in the strut yoke. Basically both are moving to some degree. Letting the hub/knucle assy move in or out.

Edit; Basically the same as Latief's link.

latief · Post by **latief** » Wed Mar 11, 2009 5:20 pm

yes, it is the same . the smaller bolt goes into the upper bolt location on the lower strut. they loosen the lower one a bit and pull the strut back or forward according to the reading. then you tighten everything down ...similar to the video above ...

Neon4Life · Post by **Neon4Life** » Wed Mar 11, 2009 7:25 pm

ok thanks.