battery tray catch can

This is the place to ask questions about your engine components like cams, valves, pistons… just anything that is generally "engine" specific. This also includes questions about exhaust systems such as exhaust manifolds, piping size, mufflers, ect...
Post Reply
neon angel
2GN Member
Posts: 667
Joined: Sat Feb 11, 2006 3:52 am
Location: belleville,ill

battery tray catch can

Post by neon angel » Sun Apr 19, 2009 11:59 am

yeah i picked one up for 20 bucks is there a way to install it with out removing the air box and going to a cai? i really like having that low end torque compared to highend powere considering im rallyxing it?
2005 neon sxt 2.0L 16v
custom cai,unorthadox udp,magnacore 8.5mmrace wires,ngk pllugs,R/T HEADER and ACTIVE R/T MANIFOLD,srt cat back,ps2 mopar lip kit and unforunately atx
Top
occasional demons
Junior Admin
Posts: 20067
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Sun Apr 19, 2009 12:07 pm

There may be room on the back of the battey, depending on the size, but then draining it may be a pain, unless you extend the drain via a tube/valve.
Bill
Probably shouldn't listen to anything your penis says, that guy's a dick.
Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
Too much time spent here is a sign of a bad case of Ownaneonvirus.

2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Top
Post Reply

Return to “Engine”