CBD Grille+Cut Cross Hairs= ?

mopar4life · Post by **mopar4life** » Thu Apr 30, 2009 11:22 pm

I got to lookin at that grille and my bumper and haz a problemz. There isnt any mounting hardware and since I dont have crosshairs Im kinda SOL as the CBD rep told me it mounts to the crosshairs some how. So how have you guys put one in without crosshairs? I suppose I could put some short short screws into the bumper and not let em go too deep and hurt the bumper?

fearingdark · Post by **fearingdark** » Fri May 01, 2009 2:38 am

if i understand you correctly, its a CF overlay for the stock crosshair? if so, you could mold it in to the bumper from the back. not sure the whole process for that, but its an idea

mopar4life · Post by **mopar4life** » Fri May 01, 2009 10:24 am

Naw its the mesh grille kit.

fearingdark · Post by **fearingdark** » Fri May 01, 2009 12:40 pm

ok...just looked at it. i think if you took a little fiberglass chop mat/resin and basically stick a bolt to the back of the bumper pointing towards the motor. then push the grill material over the bolt put on a washer and tighten it down.

sound feasible?