motor mounts and trani mounts

This is the place to ask questions about your engine components like cams, valves, pistons… just anything that is generally "engine" specific. This also includes questions about exhaust systems such as exhaust manifolds, piping size, mufflers, ect...
Post Reply
User avatar
v95
2GN Member
Posts: 2042
Joined: Sun Jul 27, 2008 5:10 pm
Location: boardwalk empire

motor mounts and trani mounts

Post by v95 » Wed May 20, 2009 11:05 am

hey was just wondering and did not see a post for it et but is there a difference in length between a non srt and srt engine mounts and trani mounts and if so how could i fab. the srt ones to fit my non srt neon
I Hate Your Neon!!!

you can not imagine immensity of the fuck that I do not give about your comment.
Top
Boyscoutgonebad
2GN Member
Posts: 365
Joined: Tue Jun 03, 2008 2:52 pm
Location: Findlay Ohio

Post by Boyscoutgonebad » Wed May 20, 2009 12:25 pm

motor mounts are interchangeable, transmission mount is not.
Image
Top
occasional demons
Junior Admin
Posts: 20064
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Wed May 20, 2009 12:29 pm

I think the passenger side mounts/TS will all interchange, but there are different PN#'s between the ATX and MTX. Prolly different rubber hardness?

The SRT MTX mount is different and I doubt it would be worth the effort.

The SRT center pass. side MM is heavier duty, but is a direct bolt in.
Bill
Probably shouldn't listen to anything your penis says, that guy's a dick.
Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
Too much time spent here is a sign of a bad case of Ownaneonvirus.

2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Top
Post Reply

Return to “Engine”