Slawmobile - SOLD
-
LilSparkPlug
- 2GN Veteran
- Posts: 12206
- Joined: Thu Jan 10, 2008 4:49 pm
- Location: RI
-
LilSparkPlug
- 2GN Veteran
- Posts: 12206
- Joined: Thu Jan 10, 2008 4:49 pm
- Location: RI
http://www.youtube.com/watch?v=c5_e7Eqb3uc
this should clear things up a bit
lsp, what kinda shows do u sigh about?
this should clear things up a bit
lsp, what kinda shows do u sigh about?

-
neonslg09
- 2GN Veteran
- Posts: 5590
- Joined: Wed May 06, 2009 7:17 pm
- Location: Fredericksburg, Virginia
Tupperware showsslaw wrote:http://www.youtube.com/watch?v=c5_e7Eqb3uc
this should clear things up a bit
lsp, what kinda shows do u sigh about?
ok so today i removed the skirts and finished putting in the projectors
later on tonight when it gets dark im gonna drive it out and align the lights properly
but for now i thought id post some updated pics!
heres the amp and cap finished up, all i need is to clean up the mess!

front bumper off




garbage pile!


new fender liners i got from asanti
just have to clean them up

and the lights all tightened down and in place


so ill align the lights tonight, hopefully install the rt skirts tomorrow, and start sanding the rear bumper wed or thursday
i pick up the front bumper friday and i hope to drop off the sanded rear then as well
later on tonight when it gets dark im gonna drive it out and align the lights properly
but for now i thought id post some updated pics!
heres the amp and cap finished up, all i need is to clean up the mess!

front bumper off




garbage pile!


new fender liners i got from asanti
just have to clean them up

and the lights all tightened down and in place


so ill align the lights tonight, hopefully install the rt skirts tomorrow, and start sanding the rear bumper wed or thursday
i pick up the front bumper friday and i hope to drop off the sanded rear then as well

lol no im not. or the fogs
im actually going to wait till the rear is off as well and sell the kit as a whole, and if not im just going to junk it
for now the car is going to sit bumperless until friday and them im going to put on the license plate and fogs and yada yada
btw idk if i did it correctly, but i tried to align my lights tonight and it seems like i failed at doing so
i measure 25 ft from my friend garage, measured from the ground to the center of the light, then marked that on the garage door, then aimed the lights to about 2 inches from the mark on the door, but i still have a hard time seeing, so its either theyre not strong enough(which means its time for HIDs) , theyre not aligned right, or my eyesight is bad
im actually going to wait till the rear is off as well and sell the kit as a whole, and if not im just going to junk it
for now the car is going to sit bumperless until friday and them im going to put on the license plate and fogs and yada yada
btw idk if i did it correctly, but i tried to align my lights tonight and it seems like i failed at doing so
i measure 25 ft from my friend garage, measured from the ground to the center of the light, then marked that on the garage door, then aimed the lights to about 2 inches from the mark on the door, but i still have a hard time seeing, so its either theyre not strong enough(which means its time for HIDs) , theyre not aligned right, or my eyesight is bad

-
LilSparkPlug
- 2GN Veteran
- Posts: 12206
- Joined: Thu Jan 10, 2008 4:49 pm
- Location: RI
-
LilSparkPlug
- 2GN Veteran
- Posts: 12206
- Joined: Thu Jan 10, 2008 4:49 pm
- Location: RI
-
LilSparkPlug
- 2GN Veteran
- Posts: 12206
- Joined: Thu Jan 10, 2008 4:49 pm
- Location: RI
-
LilSparkPlug
- 2GN Veteran
- Posts: 12206
- Joined: Thu Jan 10, 2008 4:49 pm
- Location: RI
