Looking for Specs. Head Intake CFM, Bore, Stroke, Rod Length

Perfctsouljah · Post by **Perfctsouljah** » Wed Jan 20, 2010 7:16 pm

Well like the topic says I have been trying to find the stock Head Intake CFM, The Bore Size, Stroke, and Rod Length of this motor. I have been searching for quite a while and have been unable to come up with much. So if any of you experienced tech's out there have torn apart a 2003+ Non-Magnum 2.0 and have taken these measurements then please let me know. There are several people in these forums who have rebuilt these motors so someone is bound to have this information. I figure it would be some good info to sticky aswell for whomever may have it.

-Thanks

OB · Post by OB » Wed Jan 20, 2010 7:43 pm

viewtopic.php?t=35575

Scroll down, there's some info in the engine section.

Don't count on finding CFM, unless you meet someone who's paid to have their stock head tested on a flow bench.

I also have max wear values if you need them, and lots of other odds and ends too, let me know.

stdlystdmufn · Post by **stdlystdmufn** » Wed Jan 20, 2010 8:03 pm

you can find CFM of mag heads stock and ported, on the .org

03blackrt · Post by **03blackrt** » Thu Jan 21, 2010 3:06 pm

http://www.turbort.com/flow.html

Perfctsouljah · Post by **Perfctsouljah** » Fri Jan 22, 2010 12:22 am

Thank you all very much for the info you have provided.