Excellent.gtxtreme19 wrote:OK so update:
The brown wire ran to this
coupler in front of the Ecu.
I decided to jump around it and see if there wasn't a bad connection as it was wrapped extremely well with 90mph tape.
I spliced directly into the wire about 4 inches from the PDC. And ran the wire direct to the starter and tadaa! The starter engaged! Now the wires were extremely loose so it didn't fully crank but it worked!
I didn't tighten them because it is dark already and would take a while to put it all back together. Tomorrow I will post any definite changes in the am
So it seems you found the problem ! Glad to hear it !!
- Nick