Srt boost gauge pod

heydockyle · Post by **heydockyle** » Wed Apr 21, 2010 10:13 am

What does it take to put an srt boost gauge pod in an sxt? I looked through the how tos but didn't see anything. I just want to put an oil pressure gauge in but don't want to have to cut a bunch of shit.

DR. GONZO · Post by **DR. GONZO** » Wed Apr 21, 2010 11:32 am

you gotta take the dash top off and then cut a hole throught the under section about where the bolt hole are on the inside section of the top of the dash. there is a how to for it i think i have the link

Post by **racer12306** » Wed Apr 21, 2010 12:12 pm

Yeah, for you it's really easy. All mid year 2003 - 2005 Neons have the same dash pad upper layer.

Take a look at my project log, there are some pictures in there about it. It's very easy.

You just need to cut a hole in the right spot (which you will see when you take the dash pad off). You need two screws and two push in screw clips.

Post by **occasional demons** » Wed Apr 21, 2010 12:36 pm

occasional demons wrote:IIRC there is a how to: viewtopic.php?t=21481
But it isn't all that helpful for your purpose, and has it's distractions... The wrong kind of Pods! Not that there's anything wrong there...
IIRC there is a post somewhere that shows installing on non SRT dash cover.

posting.php?mode=reply&t=30867 Which gets you to these
vvvvvv

viewtopic.php?t=14595&postdays=0&postorder=asc&start=30

http://www.cardomain.com/ride/2092484/4

heydockyle · Post by **heydockyle** » Wed Apr 21, 2010 1:58 pm

Alright doesn't sound hard at all. Thanks

neonslg09 · Post by **neonslg09** » Sat Apr 24, 2010 8:38 pm

It took a whole screw and three minutes when I had both of mine in... You're putting wayyyy too much thought into this Kyle lol

Post by **occasional demons** » Sat Apr 24, 2010 8:44 pm

Three minute screws usually don't take much thought.

theTeejmiester · Post by **theTeejmiester** » Sat Apr 24, 2010 9:50 pm

^^they do after the deed tho...