bulbs

2003silverneonsxt · Post by **2003silverneonsxt** » Mon Nov 14, 2005 9:49 pm

what bulbs do i need to change behind the hvac and under the auto shifter to blue..

i have the leds to change my window switch and sunroof switching.. and workin on the wide lense leds for behind the guage cluster (speedo, tach, gas, temp) ..

but i am stuck on the hvac and auto ones

quicksilvr · Post by **quicksilvr** » Mon Nov 14, 2005 9:54 pm

http://autolumination.com/

Go there, and find #194 LED's. You'll need ten to do all the gauges and your turn-signal and high beam indicators. Otherwise you'll just need seven.

"All you need to do is remove the fuse cover on the driver's side door, remove the screw, then the screw on the passenger side of the dash, unclip the A-pillars by pulling on them, then unscrew the two screws in the defroster part of the dash -center the windshield, lift the dash up and unscrew the gauge box (all the gauges are contained in a single box that plugs into the car), remove it and take the LED's out of the back."
*This was copied from some random guys cardomain page.....he has a sweet SRT-4. If you want to see his car and his gauges, go here
http://www.cardomain.com/ride/631408/1

EDIT - Hmm, I just noticed that you need the HVAC and shifter ones....and I don't know which ones those are...sorry.

cgneon · Post by **cgneon** » Mon Nov 14, 2005 9:56 pm

superbrightleds.com has the led twist socket combo to replace the hvac lights.....

2003silverneonsxt · Post by **2003silverneonsxt** » Mon Nov 14, 2005 9:57 pm

if u check the picture section i did all the indicator lights already..just gotta get the ones for the speedo/tach etc..and the hvac/auto shifter...

thanks for the info

2003silverneonsxt · Post by **2003silverneonsxt** » Mon Nov 14, 2005 10:25 pm

what would replace a Autometer Volt Gauge bulb? as well..is that a 194 as well?

Loud-e-nuf · Post by **Loud-e-nuf** » Wed Nov 16, 2005 12:38 pm

Yeah it's a 194, however you'd be better off trying to get the 5 LED bulb as the single LED one only light it up enough to barely read it.
________
WILLOW RUN ASSEMBLY
________
Chargeback insurance forum

2003silverneonsxt · Post by **2003silverneonsxt** » Wed Nov 16, 2005 1:45 pm

yea i planned on getting the 5 led one..just wanted to make sure what size..

thanks dude!

Post by **jonnymopar** » Thu Dec 08, 2005 9:15 am

quicksilvr wrote:http://autolumination.com/

Go there, and find #194 LED's. You'll need ten to do all the gauges and your turn-signal and high beam indicators. Otherwise you'll just need seven.

Which ones do you use? Oval wide angle?

Post by **jonnymopar** » Tue Dec 13, 2005 9:28 pm