Is it possible to remove the rear fender? **Answered**

bernaserra · Post by **bernaserra** » Fri May 21, 2010 12:20 am

I apologize if this has been asked before and I did a quick search before hand but I wanted to know if it is possible and how I could remove that rear fender. I assume its not possible but I wanted to make sure.

I've got a nasty dent on there and a colored matched donor but I am lost and my trusty Haynes guide doesn't mention how to do it.

OB · Post by OB » Fri May 21, 2010 12:35 am

If you're talking about the rear quarter panel, aka fender, then the answer is no. It is integral to the frame. You would have to cut it out and reweld in a new one, then sand, fill, and paint it.

bernaserra · Post by **bernaserra** » Fri May 21, 2010 12:43 am

[quote="OB"]If you're talking about the rear quarter panel, aka fender, then the answer is no. It is integral to the frame. You would have to cut it out and reweld in a new one, then sand, fill, and paint it.[/quote]

Thanks man, much appreciated.

s0l0d0gg · Post by **s0l0d0gg** » Fri May 21, 2010 3:06 pm

if you've got a dremel..it can be done

Post by **occasional demons** » Fri May 21, 2010 3:26 pm

It better be one that has had major steroids!

heydockyle · Post by **heydockyle** » Fri May 21, 2010 3:55 pm

Dremel that runs off 3 leg lol.

LilSparkPlug · Post by **LilSparkPlug** » Fri May 21, 2010 4:29 pm

It's welded on.....

bernaserra · Post by **bernaserra** » Fri May 21, 2010 6:43 pm

Thanks again everyone.

2GN.ORG

Is it possible to remove the rear fender? Answered

Is it possible to remove the rear fender? Answered