maxxfab SEE

bstc00 · Post by **bstc00** » Wed Aug 11, 2010 7:48 am

I didnt know where to put this so here it is. I just got a maxxfab see and it did not come with gaskets. Should there be gaskets and if so where can I get some.

Thanks
Bryce

Post by **occasional demons** » Wed Aug 11, 2010 9:47 pm

Got pics?

All I'm finding is Caliber stuff. If it has flanges, you may need to take it to NAPA, and see if they have got a match close enough to use.

bstc00 · Post by **bstc00** » Thu Aug 12, 2010 8:05 am

i got ahold of the person i bought it off and he told me no it doesnt need them. thanks for looking.

UriahRR · Post by **UriahRR** » Thu Aug 12, 2010 8:11 am

Before this thread fades away, I have a quick question, for when I go SRT I will definitely be getting one of these. But where the hell do you get them from? Is it only a used product or is there someone on srtforums that still makes them?

MoxHair · Post by **MoxHair** » Thu Aug 12, 2010 9:30 am

Side Exit is way too loud in my opinion. A lot of people buy them and like them for a time, then eventually they change to a rear exit exhaust. If I were to do it all over again I would of never done Side Exit.

bstc00 · Post by **bstc00** » Thu Aug 12, 2010 1:25 pm

UriahRR wrote:Before this thread fades away, I have a quick question, for when I go SRT I will definitely be getting one of these. But where the hell do you get them from? Is it only a used product or is there someone on srtforums that still makes them?

MaxxFab no longer makes this. You would have to get one used. I got mine from srtforums.com

neonslg09 · Post by **neonslg09** » Thu Aug 12, 2010 6:38 pm

If there is a way you can get the dimensions of the Maxxfab, you could get an exhaust shop to fix ya right up. Or just have a custom one done. I don't imagine it would be rather hard, especially if they know what they are doing.