obx lth question?

saint12 · Post by **saint12** » Thu Sep 30, 2010 6:44 pm

when installing this header i notice some people install a converter after it did you guys extend the wires for 2ed o2 sensor and install it after the converter or just leave it in the header

gtxtreme19 · Post by **gtxtreme19** » Thu Sep 30, 2010 8:06 pm

Could go without or extend the wires.

viewtopic.php?t=1025&highlight=non+fouler

saint12 · Post by **saint12** » Thu Sep 30, 2010 9:14 pm

i just want to make it look legit for visual inspections and to make sure i wont throw any codes

gilly02le · Post by **gilly02le** » Fri Oct 08, 2010 11:35 am

if your worried about this looking legit, i can tell you, it won't pass. The header ends under your cupholders under the car, so its not hidden in behind the motor by any means.

Aside from that, extend the harness plug so the lower o2 can go into the cat. You'll need to order a cat with an o2 bung in it, and you'll only have room for a round bodied cat, ovals do not fit in the exhaust tunnel.

Fuzzyneon · Post by **Fuzzyneon** » Fri Oct 08, 2010 12:37 pm

saint12 wrote:i just want to make it look legit for visual inspections and to make sure i wont throw any codes

visually they will know long tubes are really obvious and never stock

saint12 · Post by **saint12** » Fri Oct 08, 2010 1:07 pm

i am more concerned about the computer part of the inspection

Fuzzyneon · Post by **Fuzzyneon** » Fri Oct 08, 2010 2:05 pm

saint12 wrote:i am more concerned about the computer part of the inspection

Just extend the wires and you should be all good no cels

Donkeypuncher · Post by **Donkeypuncher** » Thu Oct 14, 2010 7:09 am

The magnaflow spun cats fit nicely in the exhaust tunnel, I belive they are relatively cheap as well. But yeah, an O2 bung will need to be welded in.