Will this tire fit on stock 14 rim
Will this tire fit on stock 14 rim
I currently have 185/70R/14 tires on my car. I want to get 215/60/14 tires. I have used tire calulators on the internet and the only difference is the 215 is 1.2 inches wider than the 185. Every other dimension is almost exactly the same between the two. Will this extra width fit?
2000 Plymouth Neon LX


- Pablodragon
- 2GN Member
- Posts: 567
- Joined: Sun Jun 24, 2007 9:22 pm
- Location: Westland, MI
-
racer12306
- Junior Admin
- Posts: 16015
- Joined: Sun Oct 24, 2004 8:53 pm
- Location: Baltimore, MD
- Contact:
Greg Crum had raised letters.
I'm trying to remember his username to search for it. He just had 15" wheels and normal sized tires.
I'm trying to remember his username to search for it. He just had 15" wheels and normal sized tires.
-Frank
Member of Spork Racing
Forum issues: racer12306@2gn.org
Forum Behavior
Support your favorite forum, DONATE!
Member of Spork Racing
Forum issues: racer12306@2gn.org
Forum Behavior
Support your favorite forum, DONATE!
-
occasional demons
- Junior Admin
- Posts: 20064
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
I know 195/60-14 will fit with no problems. I think you will be fine. Remember, half of the width will be to the inside, and half to the out side, unless the offset is changed. So you are only looking at .6ish inch difference in clearance.
I ran those with 6" wide wheels also. If you have alloys, they should be 6 inch. Steelies are 5.5
I ran those with 6" wide wheels also. If you have alloys, they should be 6 inch. Steelies are 5.5
Bill
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Probably shouldn't listen to anything your penis says, that guy's a dick.
Too much time spent here is a sign of a bad case of Ownaneonvirus.Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
-
racer12306
- Junior Admin
- Posts: 16015
- Joined: Sun Oct 24, 2004 8:53 pm
- Location: Baltimore, MD
- Contact:
Unfortunately I could not find any pics of Greg's (MoparKnighthawk) car.
-Frank
Member of Spork Racing
Forum issues: racer12306@2gn.org
Forum Behavior
Support your favorite forum, DONATE!
Member of Spork Racing
Forum issues: racer12306@2gn.org
Forum Behavior
Support your favorite forum, DONATE!
I don't know about 215/60/14, but I have been running 205/60/14 on all of my Neons, they fit great.
I suspect you might start running into clearance issues with 215's, going around turns.
- Nick
I suspect you might start running into clearance issues with 215's, going around turns.
- Nick
-1998 2-dr SOHC MTX= 57mm TB; Maddog STS
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm
Official "I'm Going to Drive My Neon till it Dies" Club #000009
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm
Official "I'm Going to Drive My Neon till it Dies" Club #000009
I know that BF Goodrich offers the 'Traction T/A' in a 205/60 R14 size, but I don't know if these are available lettered.badgett wrote:I would love to go with the 205's. I have to see if I can find white letters in that size.
- Nick
-1998 2-dr SOHC MTX= 57mm TB; Maddog STS
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm
Official "I'm Going to Drive My Neon till it Dies" Club #000009
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm
Official "I'm Going to Drive My Neon till it Dies" Club #000009
