need some help

apk2k6 · Post by **apk2k6** » Fri Dec 02, 2005 11:43 pm

Well I'm going to get door panels to install power options, but I need the wiring. What would be the best way to get these? I posted in the want to buy area but I knew if I asked for help here it would get more attention. Does it matter if the wiring is from a 1st or 2nd gen? This is very hard to find lol, thanks for the help.

Post by **Diablo0** » Fri Dec 02, 2005 11:59 pm

The only thing you may run into is that the dash harness wont' have the hookups for the door harness... then you'll have to manually wire them up which might be a bitch. Not sure though since I've never really taken the time to look a a base neon to see what it does and doesn't have.

Easiest way though... salavage yard.

BlackRoseRacing · Post by **BlackRoseRacing** » Sat Dec 03, 2005 10:17 am

http://electric-life.com/main.asp

or

http://www.a1electric.com/

Do a google search, if you want to install power door stuff, this is probably the way to go Vs trying to install OE parts....

apk2k6 · Post by **apk2k6** » Sat Dec 03, 2005 11:52 am

I've talked to someone that parts out SRT-4's and he said he could get me whatever I needed, but he's not sure if the wiring is different in the SRT's than other neons. Does anyone know if there are any differences?

and what EXACTLY do i need, which harnesses and etc..... thanks a lot

lilolneon · Post by **lilolneon** » Sun Dec 04, 2005 5:23 am

The electric wiring should be the same, as for what parts u need, i have no clue, my car doesnt have power anything... gotta rely on my arm muscle to do everything... cept change gears, im slowly gettin the parts to do the tranny swap!

Post by **Diablo0** » Sun Dec 04, 2005 10:01 am

The wiring is a tad different... not much but there are a few things that you may run into if you swapped over the SRT dash harness. Like if you have an '00-01 then the radio plugs will be different. If you have an '00-02 then there's a turn signal wire one pin off on the connector so you'd have move that. There might be a few more thing things that you may run into that'd you'd have to troubleshoot. Overall the whole wiring is the same, just some of the pinouts on the connectors might be different between the years. If you have an '03+ then it'd be an easy swap over since the '03+ harness looks to be about the same as far as pinouts on connectors.

apk2k6 · Post by **apk2k6** » Sun Dec 04, 2005 11:54 am

alright cool i have an '03 so i'll try it out. do you know which parts i should tell him to pull for me?

*edit* would these 2 kits do the same thing? can i hook them to the switches in the door panel? how could i install power mirrors if i got these 2 kits?

http://commandocaralarms.com/itemdetail ... ductID=603

http://commandocaralarms.com/itemdetail ... ductID=427

dblsg · Post by **dblsg** » Sat Dec 10, 2005 9:18 pm

it might be cheaper and easier to find some doors with p/w at a junkyard. that way you dont have to worry about intalling the motor and tracks for the p/w... i've heard thats a bitch to do.