srt valve covers

Dylan-00Blue · Post by **Dylan-00Blue** » Sat Jan 22, 2011 2:37 pm

This may be in the wrong spot, but im not really sure where to put it. I'm going to run a 2.0 dohc head on my 2000 turbo car this year and i was wanting the valve cover to say turbo on it. So my question is this, the srt valve covers have 2.4 on them so can i grind that off or is it just stamped onto the metal?

JeffM · Post by **JeffM** » Sat Jan 22, 2011 2:47 pm

You can grind it off; It's raised lettering. In fact, I've seen it done multiple times.

Dylan-00Blue · Post by **Dylan-00Blue** » Sat Jan 22, 2011 2:49 pm

marvelous, thanks JeffM

heydockyle · Post by **heydockyle** » Sat Jan 22, 2011 3:14 pm

Pretty sure An Srt VC won't work on 2.0 dohc head.

JeffM · Post by **JeffM** » Sat Jan 22, 2011 3:18 pm

heydockyle wrote:Pretty sure An Srt VC won't work on 2.0 dohc head.

It'll work. The oil passages are a little different between the 2.4 and the 2.0 dohc heads, but it'll still fit.

heydockyle · Post by **heydockyle** » Sat Jan 22, 2011 3:20 pm

Okay, I thought the bolt pattern was different.

sidepipe87 · Post by **sidepipe87** » Sat Jan 22, 2011 3:55 pm

I think the SRT one has an extra bolt or something.

JeffM · Post by **JeffM** » Sat Jan 22, 2011 4:30 pm

sidepipe87 wrote:I think the SRT one has an extra bolt or something.

Scratch whatever I said. I believe you're correct. After looking at a couple pictures, there are two bolts that are different. One on the driver's side edge, between the cams, and one of the spark plug tube bolts.

sidepipe87 · Post by **sidepipe87** » Sat Jan 22, 2011 4:36 pm

That sounds right. I just recall them not being a direct fit exactly. I think people have had those holes filled.

JeffM · Post by **JeffM** » Sat Jan 22, 2011 4:41 pm

It'll still bolt up along the edges just fine, and I wouldn't see it being too big of a problem, but there are two bolts that are different. I had to go look at some pictures first.

2.0 DOHC head:

SRT head:

Notice the bolt on the driver's side edge and the placement of the bolt in-between the two sparkplug tubes. My bad.

Dylan-00Blue · Post by **Dylan-00Blue** » Sun Jan 23, 2011 2:36 pm

hmmm well i may just see what i can do with it, thanks for all the info guys!

2GN.ORG

srt valve covers

srt valve covers

Re: srt valve covers