I Think i messed up!! HELP!

TheComeBackidd · Post by **TheComeBackidd** » Fri Feb 25, 2011 2:31 pm

Well im rebuilding the motor in my 02 mtx and i took out and stock engine and trans and i was inside the car doing something and i hit the clutch pedal and shot the little plunger out of the slave cylinder and all the fluid..do i have to buy a whole new system now? Please let me know if anyone has a solution..

Thanks!

Post by **occasional demons** » Fri Feb 25, 2011 3:14 pm

If the seals aren't damaged, try reassembling the slave, and then filling the reservoir. Then do the bleeding procedure.

viewtopic.php?t=35389

If it is damaged, I think you may be able to buy an aftermaket slave. The main part that is not available is the tubing.

EDIT:
Hmmm, Now the lines are available...
http://www.autozone.com/autozone/parts/ ... lfojZ6o3f2

But they don't carry the master/slave.

Advance does tho.

http://shop.advanceautoparts.com/webapp ... _577128662___

TheComeBackidd · Post by **TheComeBackidd** » Fri Feb 25, 2011 3:27 pm

ok so just push the plunger back into the cylinder, fill the res. back up and pump the cylinder up, then reassemble it to the trans and hope it works..

Post by **occasional demons** » Fri Feb 25, 2011 3:50 pm

Um, basically. At worst, you get one from Advance.

TheComeBackidd · Post by **TheComeBackidd** » Sat Feb 26, 2011 9:19 am

get a new slave cylinder from advanced? if it doesnt work?

Post by **occasional demons** » Sat Feb 26, 2011 9:39 am

TheComeBackidd · Post by **TheComeBackidd** » Sat Feb 26, 2011 4:42 pm

ok...so is that the only thing that could of got messed up from me doing this?

Post by **occasional demons** » Sun Feb 27, 2011 7:06 pm

Hopefully. Since the system is supposed to self bleed, you should be able to reassemble/replace the slave, refill the fluid, and bleed it out.

stairmaster3001 · Post by **stairmaster3001** » Sun Feb 27, 2011 8:03 pm

i have a master slave for sale that is in good condition.