Replacing SXT spoiler with a hammerhead

DetergentCandy · Post by **DetergentCandy** » Fri Jul 29, 2011 3:12 pm

nerox wrote:Are you still looking for the measurements for the hammerhead?

i've got a factory fit one on my R/T and dont mind taking some measurements or making a template if you need it ?

That would be very much appreciated!

PM'd.

nerox · Post by **nerox** » Fri Jul 29, 2011 4:33 pm

i'll get that done this weekend and get some photographs up for y'all

sidepipe87 · Post by **sidepipe87** » Sat Jul 30, 2011 9:37 am

Sorry detergent. I got your PM but was at work. If nerox can't do it, I can but it might be a while since the trunk itself is at my grandma's house right now.

DetergentCandy · Post by **DetergentCandy** » Sat Jul 30, 2011 3:24 pm

sidepipe87 wrote:Sorry detergent. I got your PM but was at work. If nerox can't do it, I can but it might be a while since the trunk itself is at my grandma's house right now.

No problem!

I'll keep you updated

nerox · Post by **nerox** » Mon Aug 01, 2011 5:08 pm

Well i haven't really had a chance to make up a template as such but had half hour free this evening so i took some photos to ease the curiosity.

LHS screw hole

RHS screw hole

Both

Inside bolt hole locations

Upper

Lower

Same as the LHS

All 4 locations

Spoiler part number

Made in Canada

Re-Assembled

DetergentCandy · Post by **DetergentCandy** » Mon Aug 01, 2011 6:04 pm

Those are awesome! From the underside, they're in completely a different location than I thought they would be

I was close...but not close

Think you'll still be able to get a template put together at some point?

nerox · Post by **nerox** » Tue Aug 02, 2011 1:27 am

Sure

DetergentCandy · Post by **DetergentCandy** » Tue Aug 02, 2011 2:05 am

nerox wrote:Sure

Can't wait!