Installing Fog Lights

sunburnedaz · Post by **sunburnedaz** » Tue Mar 22, 2011 4:57 pm

So I want to get some factory fogs installed on the 2000 neon. I already grabbed a MFS with fogs from a neon in the bone yard but the front end of the car was missing so what else do I need to install the lights? The foglight subharness and ???

Jenni · Post by **Jenni** » Thu Mar 24, 2011 11:01 am

fog lights!

Tam · Post by **Tam** » Thu Mar 24, 2011 12:16 pm

If you are interested in doing this another way instead of the factory way, you can do what I do, but you'll have HIDs.

Since the HID wiring harness only needs one headlight source for power to light up, you can get 2 HID wiring kits (1 for each side) and will supply 4 total light outputs. Then you can wire 2 into the headlight housings, and 2 into the foglight housings.

sunburnedaz · Post by **sunburnedaz** » Fri Mar 25, 2011 5:43 pm

I care less about if its factory as far as wiring harnesses go or even bulb type, housing shape. Its more of a I do not want any obvious non OEM switches in the Neon. I want it to look like it was a factory option. So now that I have the MFS installed where could I tap that signal?

Post by **occasional demons** » Fri Mar 25, 2011 9:27 pm

If the connector is wired for it, Fuse 19 in the fuse box will be powered by the fog lamp switch. You can tie in there, or at the MFS pin 14. I would use a relay to do the actual switching. The oem fogs are powered through the switch. Anything with some output will melt the MFS.