Halo Projector run-through

iThane · Post by **iThane** » Tue Jul 12, 2011 7:09 pm

i searched, i promise!

i just picked up a naked set of halo projectors and i think i need some help..
i guess just fill in the blanks or correct a statement if its wrong. this is
the information i've collected that i'm just trying to get right.

- the upper turn signal can be wired together with the three outer LED's to flash along with the turn signal
- the upper turn signal will fit the stock signal bulb
- the outer three LED's are ______ bulbs
- the main housing is designed for H1 bulbs but can fit HID's (not exactly recommended)
- the inner/smaller housing holds the high beam bulbs which are ____ bulbs
- the LED halo rings are 194 bulbs
- the halo rings can be wired to run as DRL's

the biggest issues i'm having is the fact that i've got no idea how to
wire in the halo LEDs, and the headlights came without ANY wiring..
i couldn't find much on how to wire these headlights.

iThane · Post by **iThane** » Tue Jul 12, 2011 7:26 pm

nevermind... i found stickies...

Jenni · Post by **Jenni** » Wed Jul 13, 2011 4:13 am

somewhere i made 2 drawings how to wire them up...

iThane · Post by **iThane** » Wed Jul 13, 2011 10:28 am

yup, after a bit more searching i found the two stickies and a few
drawings of wiring.

in case anyone else stumbles accross this before the stickies, here:

Projectors and HIDs: Wiring Writeup:
viewtopic.php?t=32526

PROJECTORS AND HIDS: The thread to end all threads:
viewtopic.php?t=30495