Valvecover question

unleashedcc · Post by **unleashedcc** » Tue Jul 19, 2011 8:37 pm

I just got a 1st gen aluminum valve cover with the pcv on the top. I ordered a new gasket set for it and i noticed that the bolts might be different since the rubber seals are different, true? Do I need 1st gen valvecover bolts or could I use my 2nd gen ones?

EDIT- also, does the 1st gen valve-cover require a pcv? could i just run it with an oil catch can?

sneakers O'toole · Post by **sneakers O'toole** » Tue Jul 19, 2011 9:51 pm

i can't say for sure as i just used the bolts that were already in my 1gn cover... you'll need a 1gn pcv valve though.

unleashedcc · Post by **unleashedcc** » Wed Jul 20, 2011 7:12 pm

for those that do a 1st gen valve cover swap, you will need 10 1st gen valve cover bolts (2gn will not fit) a pcv valve, and of coarse a 1st gen valve cover gasket set

took a trip to a junkyard for my bolts

Mat00ES · Post by **Mat00ES** » Wed Jul 20, 2011 10:58 pm

I used my 2nd gen bolts and they worked fine

NEON PARABOLA · Post by **NEON PARABOLA** » Fri May 11, 2012 6:56 pm

BUMP

guys help me out here, I got the pcv valve but it's obviously two diffrent diameters on the inlet and outlet sides, what sizes of tubing do i need to get from valve cover, to pcv, from pcv, to intake manni?

jckevns · Post by **jckevns** » Fri May 11, 2012 7:02 pm

viewtopic.php?t=9787

heres a how to, that should help yah out

NEON PARABOLA · Post by **NEON PARABOLA** » Fri May 11, 2012 7:36 pm

thanks!!!