i was lucky enough to have the original bushing mount and knuckle come with mine.
the rack is out of a 95 neon.
i wanted to keep the install as simple as possible. where other guy s have built a 3/4" plate to mount the unit on. i discovered it wasnt needed.
i used 3/16 plate and made a direct bolt in plate for the passenger side. i also measured to make sure the rack was sitting exactly centered compared to the original rack. as it turns out the left front bolt is in place. the other 3 need to be adapted to fit. i also built another plate to raise the right side up equally.
the K I S S worked great in this case as the knuckle lined up into the column no problems. where others found them 3/4 to short. mine seems to be maybe 1/4" short if that but i bolted it together and there lots of shaft holding it together. but to be safe i tack welded them aswell.
heres a terrible pic but gives you an idea.
also for those that car its over 22lbs weight savings
