Engine stand bolts for SRT-4 motor

MyNeonSaysHi · Post by **MyNeonSaysHi** » Mon Dec 19, 2011 2:35 pm

Searched and searched and even googled search. Does anyone have the size of the 4 bolts needed to mount a SRT-4 motor to an engine stand.
Thanks!

Hudson_Neon · Post by **Hudson_Neon** » Mon Dec 19, 2011 3:14 pm

snag a bolt that bolts your trans to your block, go to like a fastanal and get the same thing only like 4"-5" long. it won't kill your car to drive with one missing for a couple miles

Adam G · Post by **Adam G** » Mon Dec 19, 2011 4:15 pm

I just used whatever I had laying around that was long enough

MyNeonSaysHi · Post by **MyNeonSaysHi** » Mon Dec 19, 2011 11:44 pm

Hudson_Neon wrote:snag a bolt that bolts your trans to your block, go to like a fastanal and get the same thing only like 4"-5" long. it won't kill your car to drive with one missing for a couple miles

Might have to go this route, but was looking for exact specs, I be lazy.

Hudson_Neon · Post by **Hudson_Neon** » Mon Dec 19, 2011 11:47 pm

yeah, idk exact specs and the FSM doesn't say... i don't think. i'll check

EDIT: nope, nothing

DetergentCandy · Post by **DetergentCandy** » Tue Dec 20, 2011 3:25 am

Adam G wrote:I just used whatever I had laying around that was long enough

I think I used two tranny bolts and two scrap bolts.
Held the engine on a stand for a month without any issues

Post by **occasional demons** » Tue Dec 20, 2011 7:25 am

SCREW, Hex Head, M12 x 1.75 x 50

You will need to adjust length for the difference in bell housing thickness to engine stand thickness.

MyNeonSaysHi · Post by **MyNeonSaysHi** » Thu Dec 22, 2011 12:22 am

Thanks!

neonpla · Post by **neonpla** » Thu Dec 22, 2011 12:24 am

crank bolts work perfectly.

MyNeonSaysHi · Post by **MyNeonSaysHi** » Fri Dec 23, 2011 3:07 pm

Right on