SRT4 side skirts and drilling the holes

Silver-Shadow · Post by **Silver-Shadow** » Sat Mar 03, 2012 10:11 pm

Ok, I have had my srt4 side skirts for about a week or two. I tried to find some howtos on here and on youtube. No luck. So I went over a guys house and looked under his srt4 to see how to bolt up the skirts. Didn't look to bad. Alignment looks like it can be a problem. Here is my plan. Get some masking tape and mark the spots to drill the holes in the rocker panel. There was a measurement of holes on the site, I may use those measurements, don't know how accurate they are. Then drill a few holes. Anyone know what size the hole should be? Man so much can go wrong. Would be great to have the car eye level too. Anyone have any pics of the hole already drilled and/ or pics of the skirts being pressed onto the rocker panel I would appreciate it. Wish me luck.

mjrpaine · Post by **mjrpaine** » Sat Mar 03, 2012 10:26 pm

I have to change both my passenger side lower skirts later this week when it gets nice over here. I can take some measurements and pics for you while I do it. The "weatherman" says it will be in the 60's on thursday. So I plan on working on the car then ...

FAC3L3SS · Post by **FAC3L3SS** » Sun Mar 04, 2012 9:47 am

How hard did you look? There's a sticky…

viewtopic.php?t=56458

sidepipe87 · Post by **sidepipe87** » Sun Mar 04, 2012 10:16 am

I was gonna say.... i created a how to just for this...

Silver-Shadow · Post by **Silver-Shadow** » Sun Mar 04, 2012 3:56 pm

I saw and read that one, there was another one with actual pix though. Can't find that one but will go with this one.

FAC3L3SS · Post by **FAC3L3SS** » Sun Mar 04, 2012 5:18 pm

Yeah, because the write-up where someone DOES it for you is gone

sidepipe87 · Post by **sidepipe87** » Mon Mar 05, 2012 1:02 pm

Ahh ok. Sorry bud. I created this because I needed the measurements when I did it myself and figured I'd post it up to help others out. Hopefully you find it useful.

Sam10920 · Post by **Sam10920** » Mon Mar 12, 2012 12:52 pm

I had the same issue ended up just drilling a hole near the rear quarter panel, theres an indention where its supposed to be drilled that lines up perfectly to the skirt. As for the front you gotta remove that little mud guard if you have it and by doing so theres already a hole. For the rest of the skirt I went to the dealer to order the clips they looked at me blankly and had no clue so i ended up using double sided tape those things are never coming off lol hope it helps.