2000 3 speed atx to 02 pt 4 speed atx
-
CoMaToSe417
- 2GN Member
- Posts: 66
- Joined: Fri May 11, 2012 3:01 pm
- Location: Southeast MO
2000 3 speed atx to 02 pt 4 speed atx
Like the title says. I have a 2000 neon. Just bought a 02 pt for the 2.4 swap. Can i use the pt 4 speed atx or would i be better off running the stock 3 speed?
-
occasional demons
- Junior Admin
- Posts: 20067
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
You will need the entire engine bay harness, TCM, PCM to make the 41te ATX work.
The 3 speed will be simpler, the 4 speed will give you better performance from a dead stop.
The 3 speed will be simpler, the 4 speed will give you better performance from a dead stop.
Bill
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Probably shouldn't listen to anything your penis says, that guy's a dick.
Too much time spent here is a sign of a bad case of Ownaneonvirus.Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
-
CoMaToSe417
- 2GN Member
- Posts: 66
- Joined: Fri May 11, 2012 3:01 pm
- Location: Southeast MO
-
occasional demons
- Junior Admin
- Posts: 20067
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
As far as the cluster goes, it will work fine. It all runs off the PCI bus wire.
Bill
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Probably shouldn't listen to anything your penis says, that guy's a dick.
Too much time spent here is a sign of a bad case of Ownaneonvirus.Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap