fender liners from scratch?

Praesepe559 · Post by **Praesepe559** » Fri Jan 27, 2006 1:17 am

Im looking for some sort of material I can use to make fender liners that will actually match up with the body kit and be a little smoother. I have taken one of my liners into like 5 stores, a body shop, upholstry shop.. and nobody can think of where i can pick up a similar material to work with, any ideas???

Casketbearer · Post by **Casketbearer** » Fri Jan 27, 2006 1:51 am

someone on here used cheap rubber floor mats cut to fit.

joelrgr · Post by **joelrgr** » Fri Jan 27, 2006 10:37 am

Ive seen ppl use diamond-plate. Like the stuff they make tool boxes for trucks and some floor mats with. It was a little flashy but they had it chromed and it worked nicely on a slammed show car.

Praesepe559 · Post by **Praesepe559** » Fri Jan 27, 2006 2:23 pm

hmm.. not going for that flashy of a look lol. What i want is pretty much whatever the stock ones are made out of.. but if i cant get a hold of that i would lean more toward a plastic material than a rubber one. still stumped on this one..

dawm · Post by **dawm** » Fri Jan 27, 2006 5:02 pm

try going to a vinyl shop/sign shop. they might have some heavy duty material you could use

joelrgr · Post by **joelrgr** » Sat Jan 28, 2006 12:45 am

^ good idea!

juicyjay504 · Post by **juicyjay504** » Tue Jan 31, 2006 4:18 am

try somewhere like Lowes