
Messed up again!!
Messed up again!!
Well who would of thought my cars f#%ked up again. Someone decided to take there foot, fist or both to it. Nobody saw it happen and no one is admitting anything. I have two people that possibly could of done it, but like I said no one is talking. I have a feeling itll be like this for a while.



you now have somewhere to sit at car meets..

'02 Chrysler Neon RT - SOHC 50trim+Crane 007 ---DEAD---
'05 Dodge Neon SRT4 - DSP & bolt ons ---SOLD---
'08 Dodge Caliber SRT4 - MS1Kv3
Progress Log
- sidepipe87
- 2009 Silver Contributor
- Posts: 9495
- Joined: Fri May 30, 2008 5:35 pm
- Location: Pittsburgh, PA
- Contact:
Take it off and bang it out as best you can for the time being.
PM me for your 03+ PCM SKIM/VIN flashing needs. Neon PCMs Plus
-
freelancer1988
- 2GN Member
- Posts: 103
- Joined: Sat Jul 28, 2012 12:20 am
- Location: Nashville TN
-
occasional demons
- Junior Admin
- Posts: 20064
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
Wow, looks like you need about 60,000 volts/400 amps wired to your car. Scrape up the ashes, and toss them in a box in the trunk, that dumps to the exhaust as you drive down the road.
And don't forget the sprayer that puts a little moisture on the ground, when someone gets within 3 inches.
And don't forget the sprayer that puts a little moisture on the ground, when someone gets within 3 inches.
Bill
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Probably shouldn't listen to anything your penis says, that guy's a dick.
Too much time spent here is a sign of a bad case of Ownaneonvirus.Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
- MyNeonSaysHi
- 2GN Veteran
- Posts: 11898
- Joined: Mon May 23, 2005 8:46 pm
- Location: Kansas
-
04 Mo Neon
- 2GN Member
- Posts: 199
- Joined: Mon Mar 28, 2011 12:27 pm
- Location: Columbia, MO
-
2low4uneon
- 2GN Member
- Posts: 355
- Joined: Mon Jun 08, 2009 6:22 pm
- Location: Green Bay, WI
-
Midnight_Rider
- 2014 Platinum Contributor
- Posts: 8452
- Joined: Wed Aug 02, 2006 2:49 am
- Location: Indianapolis, IN
- NGCnoproblem
- 2GN Member
- Posts: 866
- Joined: Wed May 09, 2012 1:32 am
- Location: Buckley, WA
-
racer12306
- Junior Admin
- Posts: 16015
- Joined: Sun Oct 24, 2004 8:53 pm
- Location: Baltimore, MD
- Contact:
Don't think you need to worry about spraying water. That kind of power will do just fine on it's ownoccasional demons wrote:Wow, looks like you need about 60,000 volts/400 amps wired to your car. Scrape up the ashes, and toss them in a box in the trunk, that dumps to the exhaust as you drive down the road.
And don't forget the sprayer that puts a little moisture on the ground, when someone gets within 3 inches.
-Frank
Member of Spork Racing
Forum issues: racer12306@2gn.org
Forum Behavior
Support your favorite forum, DONATE!
Member of Spork Racing
Forum issues: racer12306@2gn.org
Forum Behavior
Support your favorite forum, DONATE!
Wow, I totally mis-read that exchange.
I read NGCnoproblem ask you if it was the same guy that keyed your car a while back. Then you said it was Skaterking411. I was thinking "What, can't he handle another good looking solar yellow Neon on the boards?!"
I'm a tard
I read NGCnoproblem ask you if it was the same guy that keyed your car a while back. Then you said it was Skaterking411. I was thinking "What, can't he handle another good looking solar yellow Neon on the boards?!"
I'm a tard
If I could just figure out how to meld the Outback and the Neon into one car...


- PurpleStuff
- 2GN Member
- Posts: 216
- Joined: Tue Jun 22, 2010 4:43 pm
- Location: Fuquay Varina, NC
There's a lot of things you can mess with but a persons car is a big nogo. That sucks
Build Thread....Check It viewtopic.php?t=51626
-
Midnight_Rider
- 2014 Platinum Contributor
- Posts: 8452
- Joined: Wed Aug 02, 2006 2:49 am
- Location: Indianapolis, IN
- NGCnoproblem
- 2GN Member
- Posts: 866
- Joined: Wed May 09, 2012 1:32 am
- Location: Buckley, WA
-
skaterking411
- 2GN Member
- Posts: 1006
- Joined: Mon Oct 13, 2008 8:19 pm
- Location: Akron oh









