searched but can't find

Paralyzer · Post by **Paralyzer** » Fri Jan 27, 2006 11:32 pm

I need to know how to take the black side molding off of my car. I am fed up with looking at it and it has got to go! Please tell me how to do it and what I need to use to do it. I am going car detailing tomorrow and I want them off when I do it! Please help me out!

p8ntballah413 · Post by **p8ntballah413** » Fri Jan 27, 2006 11:41 pm

you can use a heat gun or a hair dryer, let it heat up and then use a credit card to scrap it off, but be careful, when i went to do mine the paint underneath was bubbled, so needless to say the trim is still on the car for now.

OB · Post by OB » Fri Jan 27, 2006 11:41 pm

i heard a blow dryer and some fingers/credit card works fine. if its old it might take more time and leave shitty lines under from paint fade and whatnot. good luck. theres a post somewhere about this but its under a diff topic, like debadging or something. hope that helps-

03sxt · Post by **03sxt** » Sat Jan 28, 2006 12:02 am

Be extremely careful doing it. I haven't removed mine only because underneath my stripe moulding, the paint has really fine bubbles in it.

scneonchic · Post by **scneonchic** » Sat Jan 28, 2006 12:26 am

Ive heard to use fishing line...when i did mine, i just waited for a really hot summer day and sadly, used my nails and some fishing line

worked very well, and i was one of the lucky ones, no bubbles under any of my side moldings. just take your time and make sure to heat it up some, or do it on a hot day

joelrgr · Post by **joelrgr** » Sat Jan 28, 2006 12:46 am

I did mine by hand on a 80+ degree day later in afternoon after it had heated up all day. Be cautious with fishing line as it can actually cut into ur paint when pulled tight.

Neonix · Post by **Neonix** » Sat Jan 28, 2006 8:08 am

I was another lucky one and used my fingernails as well.

I just waited for a really hot day and pulled them right off, the adhesive didn't stick to the molding strip so I had to use some adhesive remover and take it off. Then a good wash/clay bar/wax and she was moldingless and beautiful!

dblsg · Post by **dblsg** » Sat Jan 28, 2006 10:49 am

i used.... oh wait a minute, mine didn't have them

03sxt · Post by **03sxt** » Sat Jan 28, 2006 3:21 pm

dblsg wrote:i used.... oh wait a minute, mine didn't have them

Paralyzer · Post by **Paralyzer** » Sat Jan 28, 2006 11:52 pm

I was going to do it today but I ran out of time and I was kinda scared to do it. I didn't want to be a oddball and get bubbles on the side of my car. But I at least got my car washed, polished, buffed, and waxed. I will considering tackling the molding later.

dblsg · Post by **dblsg** » Sun Jan 29, 2006 3:37 am

03sxt wrote:
dblsg wrote:i used.... oh wait a minute, mine didn't have them

don't hate

03sxt · Post by **03sxt** » Sun Jan 29, 2006 4:15 am

dblsg wrote:
03sxt wrote:
dblsg wrote:i used.... oh wait a minute, mine didn't have them

don't hate

Never.