00-02 vs Srt-4 neon wiring
00-02 vs Srt-4 neon wiring
Does anyone have access to, or know the wiring diagram for the 2000 engine bay harness and the Srt engine bay harness ( the two plugs that connect the engie bay harness to the junction box for the interior harness)? I am trying to compare the pins from a 2000 engine bay harness to an srt4 engine bay harness. The a/c conpressor doesn't get power when switched on (this was after my Srt swap), and I am trying to see if it is because the pins aren't matching up with my regular 00 interior dash harness. Don't want to go through switching out the dash harness, and would rather just switch pins on the connector if possible...
-Brad
-
occasional demons
- Junior Admin
- Posts: 20064
- Joined: Thu May 03, 2007 12:14 pm
- Location: Ashland Ohio
The actual connectors, and pin styles are different. the moved wires to different connectors from 2002, to 2003. I discovered this when adding cruise control to my '01, trying to use an '04 wiring diagram/connector pin out.
I believe the colors stayed the same for the most part. If you have a spare harness, you could use the internal pins, and splice the needed wires to the spares if needed, and plug those into the new connector.
I believe the colors stayed the same for the most part. If you have a spare harness, you could use the internal pins, and splice the needed wires to the spares if needed, and plug those into the new connector.
Bill
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap
Probably shouldn't listen to anything your penis says, that guy's a dick.
Too much time spent here is a sign of a bad case of Ownaneonvirus.Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap