MAP Sensor?

This is the place to ask questions about your engine components like cams, valves, pistons… just anything that is generally "engine" specific. This also includes questions about exhaust systems such as exhaust manifolds, piping size, mufflers, ect...
Post Reply
ShanesNGC
2GN Member
Posts: 28
Joined: Sun Jan 27, 2013 1:42 pm

MAP Sensor?

Post by ShanesNGC » Sat Apr 20, 2013 9:35 am

I have problems when starting from a roll, I'll push the gas in more.. But my rpm's don't seem to go any higher, My exhaust gets a louder like my rpms would be moving up.. but nothing. I slowly peak up the rpm range. When I go from a stop it does it just fine, if I push down the gas more my rpms will climb faster.

User avatar
nerox
2011 Silver Contributor
Posts: 939
Joined: Sun Dec 20, 2009 10:51 am
Location: United Kingdom

Post by nerox » Sun Apr 21, 2013 9:35 am

sounds more like throttle position sensor to me ?
Official "I'm gonna drive my Neon until it dies" Club Member UK#1

Image

occasional demons
Junior Admin
Posts: 20067
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Sun Apr 21, 2013 11:43 am

Any CEL/codes?
Bill
Probably shouldn't listen to anything your penis says, that guy's a dick.
Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
Too much time spent here is a sign of a bad case of Ownaneonvirus.

2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap

ShanesNGC
2GN Member
Posts: 28
Joined: Sun Jan 27, 2013 1:42 pm

Post by ShanesNGC » Mon Apr 22, 2013 4:27 pm

No codes or CEL at all, haven't seen one since I got the car.

esteinmaier
Supporting Vendor
Posts: 3324
Joined: Fri Dec 09, 2005 3:40 pm

Post by esteinmaier » Mon Apr 22, 2013 7:39 pm

Just sounds like a car without power to me.
ASP - First NGC SOHC in the 13s and the 12s. First SOHC neon over 500whp. First NGC Neon on MS.
Winston Churchill wrote:Yes, Madam, I am drunk, but in the morning I shall be sober and you will still be ugly.

ShanesNGC
2GN Member
Posts: 28
Joined: Sun Jan 27, 2013 1:42 pm

Post by ShanesNGC » Wed Apr 24, 2013 9:29 pm

esteinmaier wrote:Just sounds like a car without power to me.
If so, I wouldnt doubt it. Just curious if there was something wrong, or if it was just the good ole neon.

occasional demons
Junior Admin
Posts: 20067
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Wed Apr 24, 2013 10:50 pm

Probably depends on the speed, and what gear the ATX is in. And whether or not the PCM decides to unlock the torque converter.

Or how badly the floor mat is wedged under the pedal. :lol:
Bill
Probably shouldn't listen to anything your penis says, that guy's a dick.
Patience, of course, is a very powerful weapon, but sometimes I start to regret that it is not a firearm.
Too much time spent here is a sign of a bad case of Ownaneonvirus.

2000 Neon MTX swap with '02 R/T PCM
1999 neon coupe 2.4 swap

Post Reply

Return to “Engine”