3- Jaw Puller That works with UDP

ragek23 · Post by **ragek23** » Mon Jul 22, 2013 11:21 pm

Anybody know if the three jaw puller at advanced or autozone works on our underdrive pulley?

r/tguy02 · Post by **r/tguy02** » Tue Jul 23, 2013 7:08 am

The one at advance does however you'll need to fab up a longer dowel

Post by **occasional demons** » Tue Jul 23, 2013 10:23 am

UDP, or stock damper?

I'm also assuming stock, but just in case...

On some cranks, the provided dowel does work, probably one of those short drilled cranks that the tool was designed off off.

I have read a longer 1/4" extension will also work. But like I've said, start pulling it with the provided dowel, then use the longer substitute. I have tried starting with a longer homemade rod, and it bent up like a pretzel.

2005.Neon.SXT · Post by **2005.Neon.SXT** » Tue Jul 23, 2013 6:19 pm

I think I saw this on FB. But I used the one from Advance Auto, and also had to use a 1/4" extension. Worked just fine after that.

r/tguy02 · Post by **r/tguy02** » Wed Jul 24, 2013 9:28 am

i used a long hardened 3/8" bolt and cut off the head and rounded it. just in case you dont have a 1/4 extension long enough

NickKo · Post by **NickKo** » Sun Jul 28, 2013 4:53 pm

Another thing you can do:

I took my aftermarket, 'no-name brand' UDP, and drilled and tapped holes in it - so I could use a 3-leg 'steering wheel type' puller, to remove it.
Works great !!

If you do this, ^ you'll want to make sure you drill the holes *square*, and not cockeyed.

- Nick