Dyno Sheets

J8t4m · Post by **J8t4m** » Tue Feb 07, 2006 2:29 pm

Hey all

Post your dyno sheets here along with your Mods you were running at the time . . . Maybe we can cut down on the "how many Horsepower will this give me" posts

Ill be posting mine once i get my UDP and TB

nodestiny · Post by **nodestiny** » Tue Feb 07, 2006 2:34 pm

Good luck... Dyno = spendy! And for some, hard to find localy. Once i get closer to being "done" ill get dynoed, mainly to put evidence against NGC discusions (hopefully!). But it would be nice to have SOME if any dyno sheets up here...

quicksilvr · Post by **quicksilvr** » Tue Feb 07, 2006 3:22 pm

nodestiny wrote:Good luck... Dyno = spendy! And for some, hard to find localy.

Exactly.

I wish I could have already had my car to the dyno at least once, better if twice. But alas, none at all. As soon as it does actually happen though, I'll definately post it up.

CrashTeam · Post by **CrashTeam** » Tue Feb 07, 2006 5:14 pm

^ Dude theres a Dyno right outside of quincy, $45 for three pulls...

unsuper man · Post by **unsuper man** » Tue Feb 07, 2006 5:57 pm

custom turbo kit.
14.1 @ 99.7

Post by **Diablo0** » Tue Feb 07, 2006 6:36 pm

Black car

AEM CAI
Thermal RD muffler
Mopar Perf Wires
Apexi' Grounds
Unorthodox UDP
MPx 60MM TB

SSR Comp 17x7.5 semi-forged wheels (13.3lbs each).. not sure on the weight of the tires... I've been meaning to weigh them again.

OB · Post by OB » Tue Feb 07, 2006 6:48 pm

unsuper: less than 100whp WITH turbo? somethings badly wrong...

diablo: those wheels are LIGHT how much u pay for em? any more info on light wheels would be great, the wheels i was lookin into are over 20lbs @ 17x7, and if i could save 7 lbs per wheel (almost 30lbs total) that would totally be worth it. nice dyno btw i wanna do one sometime!

Post by **Diablo0** » Tue Feb 07, 2006 6:55 pm

Be prepared to spend about $1500+ just for 4 wheels then... unless you go rotas.. they're a little cheaper aren't forged.

want more info pm me as to not jack this thread.

01rtgurl · Post by **01rtgurl** » Tue Feb 07, 2006 9:09 pm

unsuper man wrote: custom turbo kit.
14.1 @ 99.7

was that a mustang dyno? dynojet????

quicksilvr · Post by **quicksilvr** » Tue Feb 07, 2006 10:04 pm

CrashTeam wrote:^ Dude theres a Dyno right outside of quincy, $45 for three pulls...

Hahaha, I didn't know that. I've never been to Quincy in my life. And it's a 1 hour drive still. Kirksville is the sticks, but I guess I'm used to it.

weber · Post by **weber** » Wed Feb 08, 2006 7:59 am

SRT Turbo setup, custom IC piping. SRT stock exhaust.

Also, this is on a Mustang Dyno, rates 15% lower than DynoJet.

so in otherwords, 174.8 HP with 201 ft lb. @ 5 PSI