Instrument cluster is dim

Questions about interior lighting, shift knobs, just anything mainly to do with modifications on the inside of the car. Ask those questions here.
Post Reply
Dennis Blewett
2GN Member
Posts: 31
Joined: Tue Jul 22, 2014 5:36 am

Instrument cluster is dim

Post by Dennis Blewett » Sat Aug 30, 2014 2:45 am

Part of the instrument panel in the 2000 Dodge Neon is dim. What bothers me the most is the speedometer. It's dimmer than other areas of the panel. I, at least, don't believe it's an illusion of my mind. It's somewhat dim but not completely dark. It's dim enough to be an annoyance. Any advice would be welcomed.

User avatar
Gnuserup
2GN Member
Posts: 661
Joined: Sun Jun 28, 2009 3:06 pm
Location: Germany

Post by Gnuserup » Sat Aug 30, 2014 4:13 am

replace the bulb ?

The bigger grey plugs...

Image
a neon - what else ?

occasional demons
Junior Admin
Posts: 18973
Joined: Thu May 03, 2007 12:14 pm
Location: Ashland Ohio

Post by occasional demons » Sat Aug 30, 2014 9:56 am

Bulb could be either burnt out, or near the end of it's life. They can blacken the inside well before they fail.

Also the contacts can get slight corrosion on them, or the tension gets weak, causing poor conductivity. I currently have that issue, as the lights intermittently fail to work, at random locations in the cluster.
Bill
dblsg wrote:ya'll a bunch of post whores
epic

2001 Neon ES MTX with '02 R/T PCM
Help support 2GN!

NickKo
2009 Gold Contributor
Posts: 2248
Joined: Sun Jun 11, 2006 11:24 am
Location: IL./WI.border

Post by NickKo » Sat Aug 30, 2014 4:11 pm

It is a very good idea to check and clean the grounds. :!:

Two places to check:

1). The grounds that attach to the upper radiator core support, near the headlamps. Very Important.
These are the grounds for the drivers in the PCM.

2). There is also a ground inside the dash.
On 1st gen Neons, this is behind the radio. I don't know about the 2nd gen Neons, but I assume it is the same.




For the grounds - Be sure to wire brush and clean these down to bare metal - Including the wire lugs/terminals and attaching screws.

After cleaning and re-attaching everything, be sure to use something as a rust inhibitor. At the very least, something like PB Blaster - Or coat these with dielectric grease, or Vaseline, to 'seal off' corrosion.
(Again, you'll only want to apply this after re-attaching everything.)

Be sure to NOT operate any accessories with these grounds disconnected. It may not be a bad idea, to disconnect the battery to prevent any accidents - Until you are done.


After cleaning the grounds on the upper radiator core support on our 2nd gen - I noticed that the dash cluster lights, were (noticeably) brighter.
I noticed the difference, even during daytime. :D I know that this helps.


- Nick
-1998 2-dr SOHC MTX= 57mm TB; Maddog STS
-2000 Ply.LX w/MTX = Maddog STS; CAI; 2.5 exh.; 60mm T/B
-2001 ATX w/Syked PCM + Magnum header
-2001 ACR w/SRT T/B bored out to 55mm

Official "I'm Going to Drive My Neon till it Dies" Club #000009

Post Reply

Return to “Interior”