Two questions...
1. I can't figure out where I should drill to run the power wire from the battery to the trunk
2. How did you get your speaker wire into your doors? I tried going through the rubber thing with all of the other wires but its hard as a bitch.
Two stupid install questions
Two stupid install questions
http://www.cardomain.com/ride/2217253
Sold my neon a while back.
Sold my neon a while back.
-
Loud-e-nuf
- 2GN Member
- Posts: 190
- Joined: Tue Sep 20, 2005 10:43 am
- Location: Georgia
I went through the grommet where the main harness runs into the dash, I ran 1/0 through along with my alarm/remote start wire so there's plenty of room. For the door speaker wires I broke one of the 4 corner tabs out of the harness connector which allowed plenty of room to run 14ga wires through. FYI if you didn't figure it out you have to squeese all 4 corners of the connector on the body side of the door harness and it will pull out giving you about 4-6" of clearance to work with.
________
DAIMLER REGENCY
________
ZX14 VS HAYABUSA
________
DAIMLER REGENCY
________
ZX14 VS HAYABUSA
Last edited by Loud-e-nuf on Fri Feb 18, 2011 1:07 am, edited 2 times in total.
Thanks... I found a lot of answers on the other org about the power wire so hopefully tomorrow when its light out ill be able to get it done. Here is that thread if anyone else would care for future reference http://forums.neons.org/viewtopic.php?t=251159
http://www.cardomain.com/ride/2217253
Sold my neon a while back.
Sold my neon a while back.
-
neonlight18
- 2GN Member
- Posts: 164
- Joined: Fri Apr 07, 2006 9:50 am
- Location: Warner Robins, GA
- Contact:
