Gasket Material?

Neonix · Post by **Neonix** » Fri May 05, 2006 4:19 pm

This is probably in the wrong section (Sorry Jason) but if I were to make a gasket, which material would be best to use? Is there even a difference?

Thanks guys!

cnfx-wicked · Post by **cnfx-wicked** » Fri May 05, 2006 4:27 pm

where is the gasket to be used, what material depends on the location

Neonix · Post by **Neonix** » Fri May 05, 2006 4:33 pm

From the header to the downpipe. I have the gasket for the header to the engine.

dinetuner · Post by **dinetuner** » Fri May 05, 2006 4:36 pm

paper... or aluminimun... or check that new metal they now make struts out of... check in the suspension forum...hehehe

Neonix · Post by **Neonix** » Fri May 05, 2006 4:47 pm

Ok. I'll just have to go to the parts store and look. Thanks!

dblsg · Post by **dblsg** » Sat May 06, 2006 3:59 am

high temp RTV. that should work.