prothane race inserts

sneakers O'toole · Post by **sneakers O'toole** » Sun Jun 11, 2006 7:30 pm

ok,so i'm putting these in this weekend and i've never done this before. just wondering if there is any chance of snapping the bolts when i tighten them up a-la valve cover bolts, or is that not something to worry about. i dont think so but its better to be sure.
i'll be using hand tools by the way..yeah fun..ha. and i assume useing a jack to brace the engine even if i do one at a time is a good idea, yes?

thanks,
harry

MoxHair · Post by **MoxHair** » Sun Jun 11, 2006 7:42 pm

http://forum.2gn.org/viewtopic.php?t=4978

As it says there

nodestiny wrote:Remove the bolt, push the insert in (goes in well after a good push) and bolt it back up with washer. Must be pretty dumb to mess this install up...

daaboots · Post by **daaboots** » Sun Jun 11, 2006 7:42 pm

You shouldn't break the bolts. You wont need to brace the engine with a jack either. Just do one at a time and you'll be ok

sneakers O'toole · Post by **sneakers O'toole** » Sun Jun 11, 2006 11:12 pm

cool man, thanks

sneakers O'toole · Post by **sneakers O'toole** » Mon Jun 12, 2006 6:40 pm

if i wouldve known that these things were so simple to put in i wouldnt have let them sit around for 3 months,ha.

p.s. i hate push pins

harry

BlackRoseRacing · Post by **BlackRoseRacing** » Mon Jun 12, 2006 7:55 pm

you have been pm'd