K&N filter

Blazers04bluSXT · Post by **Blazers04bluSXT** » Tue Jun 20, 2006 8:16 pm

do i need to get a new K&N (different size) for the ebay intake i just bought or will the one i have in place for the stocker work?

dblsg · Post by **dblsg** » Tue Jun 20, 2006 10:23 pm

it might work... if it dosen't match the diameter, you could always get an adapter for it from a hardware store.

Blazers04bluSXT · Post by **Blazers04bluSXT** » Tue Jun 20, 2006 11:16 pm

but as far as how big the drop in is. will it fit up in that space?

Post by **Diablo0** » Wed Jun 21, 2006 12:47 am

Hmmm... it might be a tight fit. I'd say it might work as far as fitting in the fender well.

koreysxt · Post by **koreysxt** » Wed Jun 21, 2006 2:44 pm

It will fit fine. The filter I was using was quite a bit larger than the stock one. K&N drop-in should be identical size to the stock filter. You'll just have to loosen the inner fender well lining, and slide it up from underneath. The 2.5" ID should also fit fine (I know -- as I have experience with this CAI:) ) I never had to completely remove the fender well lining, or tire/wheel when I added/removed it.

Do you still have the huge air silencer box in the fender? This was really tight, but I still was able to get it out w/o removing the wheel/tire.

Blazers04bluSXT · Post by **Blazers04bluSXT** » Wed Jun 21, 2006 4:16 pm

thats good to hear. something i dont have to buy

Blazers04bluSXT · Post by **Blazers04bluSXT** » Wed Jun 28, 2006 6:05 pm

it actually fit perfectly... no problems at all with the installation.